Tips For A Easily Installation Process Of A Monitor In A Auto
A single monitor may not be very effective in big cars and vans. In such situation, multiple monitors would ensure good visibility to all in all parts of the car. This can be done by fixing additional monitors either on the roof of the car or behind the seats. The important question is how to wire additional monitors to a car DVD?
The first and foremost thing to be done for adding monitors is to analyze and find the size of the monitor to be used. There are a set of tools required for accomplishment of this task. It includes paper, felt tip marker, hook and loop fasteners, pencil, tape measure, scissors, RCA cable Y adapter. These tools simplify the task of wiring additional monitors to a car DVD.
For knowing the size of the largest monitor that can be installed first use a tape measure to get the correct size of the head rest of the front seat. The head rest is removed and it is placed on a work bench or any other flat surface. This helps in a much safer and comfortable processing.
The next thing to do is to create an template of the DVD monitor. To create it first place the DVD monitor on a sheet of paper then mark the outline using a pen or a pencil. Now it is time to move on to the head rest. Now place the template of the Disc player on the head rest and plot the outline on it and then mark the spot.
A hole that is small in size is cut out in the bottom of headrest. This will give enough room for the wires that are needed for connecting the DVD screens. The fasteners that are available are then placed with one end on the metal base and placed it back into the seat. The wires have to be connected by running it through headrest bars, seats and the floor. In the floor, the carpet can be cut open with tiny holes. The wires can then be run to the dashboard to the head unit of the Disc player.
After the foam is removed, one small hole is drilled in the bottom part of headrest. This will allow the wires to pass through that are necessary for connecting the monitor for DVD player. The fasteners are then placed in such a way that one end is on the metal base and then is set to position.
It is advisable to use pencils and not use permanent markers since it will not spoil the appearance of the seat. It is also essential not to start cutting headrest in the wrong spot which might lead permanent damage to the seat. The adapter may be used for additional connections.
If the above instructions are followed with proper vigilance many monitors can be fixed. There are few warnings that are given also to not to spoil the aesthetics of the car. This is how to wire additional monitors to a car DVD.
Looking to find the best deal on Auto Hifi, then visit www.powernetshop.at to find the best advice on Car audio for you.